Denon AVR-1803 Operating Instructions Manual page 21

2 Select the DTS NEO:6 mode.
(Main unit) (Remote control unit)
• The mode switches as shown below each
time the button is pressed.
DOLBY PL II cinema
DTS NEO:6
3 Play a program source.
4 Select the surround parameter mode.
Display
MODE cinema
(Main unit) (Remote control unit)
To perform this operation from the remote
control unit, check that the mode selector
switch is set to "AUDIO".
5 Select the optimum mode for the source.
(Main unit) (Remote control unit)
MODE cinema MODE music
or or
6 Set the surround parameters according to the
mode.
(Main unit) (Remote control unit)
• The mode switches as shown below each
time the button is pressed.
MODE CINEMA MODE MUSIC
CINEMA EQ CENTER IMAGE
DEFAULT DEFAULT
7 Set the various surround parameters.
• CINEMA EQ setting
CINEMA EQ OFF
OFF ON
or or
• CENTER IMAGE setting
C.IMAGE 0.2
0.0 0.2 0.5
or or
• DEFAULT setting
DEFAULT Y/N
YES Y/N NO
or or
Select "Yes" to reset to the factory defaults.
8 Press the ENTER button to finish surround
parameter mode.
(Remote control unit)
Surround parameters q
Pro Logic II Mode:
The Cinema mode is for use with stereo television shows and all programs encoded in Dolby Surround.
The Music mode is recommended as the standard mode for autosound music systems (no video), and is
optional for A/V systems.
The Emulation mode offers the same robust surround processing as original Pro Logic in case the source
contents is not of optimum quality.
Select one of the modes ("cinema", "music" or "emulation").
Panorama Control:
This mode extends the front stereo image to include the surround speakers for an exciting
"wraparound" effect with side wall imaging.
Select "OFF" or "ON".
Dimension Control:
This control gradually adjust the soundfield either towards the front or towards the rear.
The control can be set in 7 steps from 0 to 6.
Center Width Control:
This control adjust the center image so it may be heard only from the center speaker; only from the
left/right speakers as a phontom image; or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
DTS NEO:6 MUSIC:
CENTER IMAGE (0.0 to 0.5: default 0.2)
The center image parameter for adjusting the expansion of the center channel in the DTS NEO:6 MUSIC
mode has been added.
Dolby Digital mode (only with digital input) and DTS Surround (only with digital input)
1 1 3
3 2 2 2
1 Select the input source.
Playback with a digital input
q Select an input source set to digital (COAXIAL/
OPTICAL) (see page 12).
Example: DVD/VDP
(Main unit) (Remote control unit)
w Set the input mode to "AUTO" or "DTS".
(Main unit) (Remote control unit)
ENGLISH
2
1
4, 5, 6, 7, 8
9
5, 6, 7, 8 5, 6, 7, 8
3
5, 6, 7, 8
1
21