Options Available; Control Lock; Display Dim - Maytag GEMINITM User Manual

To Change Factory Set Default Options:
1. Control options may be changed by se-
lecting the Setup Options (0) pad and the
desired option pad. (See Options below.)
2. Current option will appear in the display.
3. Press the AUTO SET pad to change the
option.
4. Press CANCEL pad to set the displayed
option and exit the program.

OPTIONS AVAILABLE:

12 H O (1)
OUR FF
The oven may be set to turn off after 12
hours or stay on indefinitely. The default is
set to turn off after 12 hours.
T B (2)
IMER EEPS
There are three choices for the end of
"timer" reminder signals.
One beep followed by two beeps every 30
seconds for up to five minutes (default
setting).
One beep followed by two beeps every
minute for up to 30 minutes.
One beep followed by no other beeps.
C T B (3)
OOK IME EEPS
There are three choices for the end of
"clock controlled cooking" reminder sig-
nals.
Four short beeps followed by one beep
every minute for up to 30 minutes (default
setting).
Four short beeps followed by no other
beeps.
Four short beeps followed by one beep
every 30 seconds for up to five minutes.
C L (4)
ONTROL OCK
The function pads on the control can be
locked to prevent unwanted use for safety
and cleaning benefits. The current time of
day will remain in the display.
S S (5)
CROLL PEED
The scroll speed of the messages in the
display may be changed from FAST to
MEDIUM to SLOW. The default is set for the
medium speed.
D D (6)
ISPLAY IM
The control intensity may be changed for
easier reading. The default is set for the
highest intensity ********. The fewer ***** the
less the intensity.
T C/F (7)
EMP
The temperature scale may be changed to
Centigrade or Fahrenheit. The default is set
for Fahrenheit.
L (8)
(select models)
ANGUAGE
The words which scroll in the display may
be changed from English to French or Span-
ish.
D (9)
EFAULT
The control can be reset to restore the
factory setting for each option.
D O /O (C )
ISPLAY N FF LOCK
The time-of-day display may be shut off
when the oven is not in a cooking or clean-
ing function.
O T A
VEN EMPERATURE DJUSTMENT
If you think the oven is operating too cold or
hot, you can adjust it. Bake several test
items and then adjust the temperature set-
ting not more than 10 F at a time.
To Adjust:
1. Press the BAKE pad (upper or lower
oven) and enter 550 F.
2. Press and hold the BAKE pad (upper or
lower oven) for several seconds until
TEMP ADJ is displayed.
3. Press the AUTO SET pad - each press
changes the temperature by 5 F. The
control will accept changes from -35 to
+35 F.
4. If the oven was previously adjusted, the
change will be displayed. For example,
if the oven temperature was reduced by
15 F, the display will show -15 F.
5. When you have made the adjustment,
press the CANCEL pad and the time of
day will reappear in the display. The
oven will now bake at the adjusted
temperature.
The oven lights automatically come on when
the doors are opened. When the doors are
closed, press the LIGHT pad (upper or
lower oven) on the control panel to turn the
lights on or off.
The oven lights will not operate during a
clean cycle. The oven lights will come on
automatically one minute before the end of
a clock controlled cooking operation.