GE 19 Use And Care Manual page 21

REVERSE HARDWARE OH CABINET
one (see page 3). Grasp it at the bottom and pull it
straight out.
4'\
b. Using aT20 Torxdriver, remove the hinge (and
shim glued to it) and plastic washer from the
bottom right side of the cabinet.
PLASTIC
c. Reinstall the hinge (and shim glued to it) and
plastic washer to the bottom left side of the cabinet.
PLASTIC
WASHER
——————_
—
DO NOT REMOVE
THIS SCREW
a. Remove the hinge bracket (and shim glued to
it) from the center right side of the cabinet by
removing the three outermost Torx screws.
b. Remove the three outermost Torx screws from
the center left side of the cabinet and screw them
into the holes at the right side uncovered in Step (a)
above.
CENTER LEFT
Place the center hinge bracket over the holes at the
center left side of the cabinet, insert the screws you
removed from the opposite side, and tighten them.
TRANSFER TOP HINGE TO THE LEFT.
Interchange hinge and screws at top right with
screws at top left of cabinet. Do not tighten
screws on
hinge side at this time.
DOOR-
a. On each door, move the
metal door stop from the
right end to the left end.
b. Move any screws from
the left end to the right end.
I
DO NOT REMOVE
THIS SCREW
II
—
(continued next page)
21