[Incomplete Tx Hold]; [Pc-Fax Permission Setting]; [Pc-Fax Rx Setting]; [Tsi User Box Setting] - Muratec MFX-C2280 Fax Manual

[Incomplete TX Hold]

To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Function Settings] - [Incomplete TX Hold]
Configure the settings for using the Fax Retransmit function.
Fax Retransmit is a function that stores a fax that could not be sent by Redial in the machine's user box for
a given period of time. A stored fax job can be resent later by recalling it from the box.
Settings
[Yes]/[No]
[File Storage Duration]

[PC-Fax Permission Setting]

To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Function Settings] - [PC-Fax Permission Set-
ting]
Select whether to allow PC-Fax TX using the fax driver.
[Allow] is specified by default.

[PC-Fax RX Setting]

To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Function Settings] - [PC-Fax RX Setting]
Configure the settings for using the PC-Fax RX function.
PC-Fax RX is a function that automatically saves a received fax to the Compulsory Memory RX User Box or
a user box specified in F-Code (SUB Address). A stored fax job can be read from a user box into a computer.
Settings
[Allow]/[Restrict]
[Receiving User Box Desti-
nation]
[Print]
[Password Check]

[TSI User Box Setting]

To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Function Settings] - [TSI User Box Setting]
Configure the settings for using the TSI Routing function.
TSI (Transmitting Subscriber Identification) is a sender's fax number. TSI (Transmitting Subscriber Identifica-
tion) Routing is a function that automatically sorts incoming faxes into preset boxes or redirects them to user
computers or E-mail addresses based on the fax numbers of the senders.
Settings
[Yes]/[No]
[Action when TSI User Box
is not set.]
Description of Setup Buttons (Administrator Settings)
Description
Select whether to use the Fax Retransmit function.
[No] is specified by default.
Specify the time period during which a fax failed to be sent is stored in the
machine's user box.
[12 Hours] is specified by default.
Description
Select whether to use the PC-Fax RX function.
[Restrict] is specified by default.
Select either [Memory RX User Box] or [Specified User Box] (a User Box
specified in F-Code (SUB Address)) as the location to save received faxes.
Select whether to print a received fax after it has been received.
[OFF] is specified by default.
If you select [Specified User Box] for [Receiving User Box Destination], se-
lect whether to check the communication password (sender ID) for PC-Fax
reception.
If [ON] is selected, enter the requested password (a number containing up
to eight digits).
Description
Select whether to use the TSI Routing function.
[No] is specified by default.
Select the action to be taken by the machine if a fax numbers (TSIS) is not
registered and no forwarding destination is received.
• [Automatically Print]: Prints a received fax without saving it in a box.
• [Memory RX User Box]: Saves received documents in Memory RX User
Box.
• [Specified User Box]: Saves a received fax in a box specified by User
Box Number.
11
11-27