Yaesu FTM-100DR Operating Manual page 107

10
On the transceiver from which data is to be copied,
rotate the DIAL to select [OK?], then press
The data copy starts.
When data copy completes, "Completed" appears.
The FTM-100DR transceiver to which you copy the
data restarts automatically. The screen displayed
differs depending on the copied data.
11
On the transceiver from which data is to be copied, press and hold
one second.
The display returns to the previously viewed operating screen.
12
Turn off the both transceivers, then disconnect the clone cable.
Cautions
z When "ERROR" appears on the screen during the copy (clone) operation, the copy (clone)
operation has not completed. Check the clone cable connection, and perform the operation from the
beginning.
z To ensure the security of your data, it is recommended to copy your backup file onto a microSD
memory card.
z If the operation is terminated due to power loss during the copy (clone) operation, the transceiver
to which the data copies will be reset automatically. Check that there is no abnormality in the power
supply and perform the operation again from the beginning.
Copying the radio data to another transceiver
.
for over
107