Assembling Blade Guard And Sp L I T T E R Assembly - Delta 36-475 Instruction Manual

2 . Fig. 24, illustrates the motor cord connected to the
switch assembly.
ASSEMBLING
B L A D E GUARD A N D
SPLITTER A S S E M B LY
W ARNING: M A K E C E R TAIN T H E S AW I S DISCON-
NECTED F R O M THE P O W E R S O U R C E.
1 . Fasten the rear splitter mounting bracket (A) F i g . 2 5 ,
to the rear trunnion using the two 3/4†hex head screws
(B) and flat washers. Do not completely tighten the two
screws (B) at this time.
2 . W ith wrenches supplied, remove the saw blade from
the saw. R e f e r t o s e c t i o n CHANGING THE S AW BLADE
on page 28, of this manual. Raise saw arbor to its high-
e s t p o s i t i o n .
3 . Remove screw and large washer (C) Fig. 26, from
the inside splitter mounting bracket.
4 . Using a straight edge, check to see if the top and
bottom of the inside splitter bracket (D) Fig. 27, is aligned
with the inner arbor flange (E), as shown.
C
12
Fig. 24
A
B
Fig. 25
Fig. 26
D
E
Fig. 27