Table of Contents
Advertisement
A R M I N G S T A Y : P R O T E C T I N G Y O U R S E L F AT H O M E
Arming in the Stay mode allows you to remain home with the perimeter protection active but with the interior protection off,
so that you may move freely within the premises. Arm Stay at the Garage Touchpad as follows:
1
Check the Touchpad indicators. The green
play will read "SYSTEM READY", indicating that the system is ready to arm.
SYSTEM READY
2
Press the STAY button.
The Touchpad will voice prompt the correct action.
STAY
3
If the garage door is already closed, the ARMED indicator will light and the LCD display will read
"ARMING STAY". The system will arm in the Stay mode within 3 minutes.
ARMED
4
If the garage door is NOT closed, close the garage door from the inside to arm the system.
8
• If the green STATUS light is off and zones are scrolling in the display, a perimeter zone is faulted or a moni-
tored deadbolt (other than your exit door) is unlocked. Check the open zones listed and close the door,
window, or lock the deadbolts as needed. If you cannot immediately secure the zones or lock the deadbolts,
they may be bypassed (see page 7).
•
If you change your mind after pressing AWAY, press RESET to clear arming.
If the garage door has not been closed within the exit delay time period (usually within 3 min-
utes of pressing STAY, but this time period can be changed by your installer), the system will
revert back to a disarmed state. (Note: See page 13 if your garage door motor fails).
light must be ON-STEADY, and the LCD dis-
STATUS
"The system is arm-
ing in Stay mode"
Advertisement
Table of Contents
