NAPCO F-64TPG Operating Manual page 23

DELETE I-FOB
U S E R P R O G R A M M O D E
to the system. Create a User I-FOB as follows:
1. Obtain a new I-FOB from your security professional (order part F-IFOB).
2. With "CREATE USER I-FOB Y/N" displayed in the LCD window, press "Y" and the
LCD window will request to insert the new I-FOB into the Touchpad.
3. After 5 seconds, the I-FOB will be programmed, and you will be prompted to remove
the I-FOB from the Touchpad.
It is recommended that you record the name of each person in possession of each User
I-FOB so that you will know which I-FOB user number to delete from the system, as de-
scribed in the next section.
Remove I-FOB's From The System
Y/N
In the event that a User I-FOB is lost, use the following procedure to remove I-FOB's
from the system, except the Master I-FOB*:
On a disarmed system:
1. Enter the User Program Mode as described above.
2. Press MENU until "DELETE I-FOB Y/N" displays in the LCD window. Press YES
and "DELETE ENTRY USER I-FOB U02" will appear in the LCD window.
3. Press ENTER and the confirmation message "U02 DELETE ENTRY Y/N" will appear.
4. Press YES and after a short processing interval, the Touchpad will read "U02 DE-
LETED DELETE AGAIN Y/N". Press YES to remove another I-FOB user number
from the system, or press NO to return to the User Program Mode.
Exit the User Program Mode
• When you have completed programming or erasing User Codes, press RESET to exit
the User Program Mode.
*
In the event that the Master I-FOB is lost, contact the alarm company to arrange a replacement.
23