Table of Contents
Advertisement
Congratulations on your purchase of a
new Freedom Garage Door Security Sys-
tem.
This revolutionary new concept in
residential security makes using your sys-
tem easier than ever before possible, be-
cause the system uses its computerized
control panel to continually monitor the
status of your garage door.
anticipates what command it should ex-
pect from you next--simply requiring just
one button to press to effortlessly operate
your security system, whether you're go-
ing, returning or staying in for the night.
1
Test your sounding device and backup battery
(Perform these tests only on weekends or at a time designated by your
alarm company)
1. While disarmed, press MENU.
2. Press MENU until ACTIVATE SIREN TEST appears in the display.
3. Press YES to execute the test. The alarm will sound for about two
seconds.
• If the alarm does not sound, call for service.
• If the battery is low, LOW BATTERY E02-00 SERVICE will appear
in the display indicating a low battery condition. Allow 24 hours for
the battery to recharge. If the trouble continues, call for service.
2
I N T R O D U C T I O N
Now everyone in your family, young and
old alike, will enjoy the true peace-of-mind
you would expect from a quality, state-of-
the-art NAPCO Security System, without
the fuss of remembering confusing nu-
merical codes to operate it.
Simplicity and convenience begin with
It actually
your System's one-touch STAY or AWAY
buttons, then just open or close the garage
door as usual! Day in and day out, that's
all there is to it.
This booklet contains important in-
formation about the operation of your
IMPORTANT - TEST YOUR SYSTEM WEEKLY
From a Ready Condition (Disarmed State)
NAPCO
Please read it through and retain it for
handy reference. Because your system is
customized for your home and lifestyle,
you may find subjects mentioned here,
that do not apply to your system.
assured your security system has been
configured by your Security Professional
to best suit you and the system itself has
been meticulously designed and engi-
neered to the highest industry standards.
Please test your system at least once a
week as described below.
2
Test your central station communicator
(Activate Dialer Test programmed?
1. Notify your Central Station of the impending test.
2. While disarmed, insert your I-FOB into the Touchpad. Press MENU.
3. Press MENU until ACTIVATE DIALER TEST appears in the display.
4. Press YES to send a test code to the central station.
• If the test is not successful, COMM FAIL E03-00 SERVICE will
display, indicating a communication failure. Call for service.
Note: Any subsequent successful transmission will clear a Failure to
Communicate system trouble.
Freedom
Security
System.
YES
NO)
Rest
Advertisement
Table of Contents
