Table of Contents
Advertisement
4. Enter the new value in the Form Bar Code field. If you change the value to
0000, bar code checking will no longer be done for this form when it is loaded
in the future.
5. Select OK to accept the new value.
Defining a form bar code for a new Snapshot
Before you begin
About this task
Do this procedure to define a form bar code for a new Snapshot.
Procedure:
Procedure
1. Select the Form Settings panel (Forms → Form Settings).
2. Enter a four-character hexadecimal value from 0000 to FFFF in the Form Bar
Code field. This hexadecimal number must match the binary code for the
preprinted bar code.
This value must match the value of the bar code printed on the form you are
defining. If you enter 0000, you are "turning off" (disabling) bar code checking.
The printer will not look for a bar code when the form is being loaded.
3. Make sure that all printer settings are set the way you want them to be saved.
4. Select the Snapshots panel (Frequent Tasks → Snapshots).
5. Select Save current settings as... and enter a name for the new Snapshot.
6. Select OK.
7. Select Close to return to the Main panel.
Loading preprinted bar code forms
About this task
When you load forms for simplex or duplex printing, whether the forms are
fan-fold (boxed) forms or continuous roll forms, the edge with the preprinted bar
code must be facing up and toward the front of the printer, that is, the edge closest
to you as you load the forms.
Important:
Ensure that the forms are threaded below the forms bar code sensor(1) so that the
sensor's light is centered on the bar code mark (2).
419
Appendix. Features
Advertisement
Table of Contents
