Ricoh InfoPrint 4100 TS2 Operating Manual page 34

8
3
Figure 15. Vacuum, stack height, lift pin lever, and puller controls
Selecting This Control
Vacuum Push Button (4)
Puller Lever, Release (6)
Puller Lever, Printing (6)
20
Operating the InfoPrint 4100
1
9
7
Does This:
Turns the vacuum on or off in the fuser area.
The vacuum holds the forms against the preheat platen,
which partially fuses the toner to the forms. The
Vacuum-Off Warning indicator is to the right of the
vacuum push button. This indicator comes on to warn
you that the forms-path vacuum is off.
Releases pressure on the scuff and backup rollers inside
the fuser area. To release these rollers, move and hold
the puller lever to the release position.
Applies pressure to the scuff and backup rollers inside
the fuser area during the printing process. The lever is
spring loaded in this position, so pressure is normally
applied to the scuff and backup rollers.
4
5
6