Ricoh SP 3600SF User Manual page 111

Message
"Cannot
connect=>Comm.Serv.
Check proxy user/
password."
"Change (Tray name) to the
following settings:"
"Cover Open. Please close
the indicated cover."
"Duplex mode is in off
position for (tray name)"
"Enter password."
"Failed to connect to server
for Remote Diagnostics."
"Independent-supply toner"
"Load paper in (tray name)"
"Prepare Replacement
Check print cartridge
replacement(s)."
"Replacmnt Requrd Maint.
Kit"
Causes
The proxy user name or
password is incorrect.
The size of the paper in the
tray does not match the
paper size specified in the
printer driver.
A cover of the machine is
open.
The duplex mode for the
indicated tray is not
available.
User Restriction is enabled.
The machine cannot
communicate with Remote
Communication Gate.
Independent-supply toner is
set.
There is no paper in the
specified tray.
The toner has run out.
You need to replace the
maintenance kit.
When Messages Are Displayed on the Control Panel
Solutions
Check the proxy server settings, and
then change the user name and/or
password if they are incorrect.
Press [Change] to change the paper
size and type settings of the tray, as
indicated on the screen, and then load
the appropriate paper in the tray.
Otherwise, press [JobReset] to reset the
job, or press [Form Feed] to force
printing by specifying another tray.
Close the cover as indicated on the
control panel.
Press [Change] to change the tray
setting to allow duplex printing, or
press [JobReset] to reset the job.
Otherwise, press [Form Feed] to print
on one side of a sheet.
Contact your administrator for the
password.
Check the connection to the Remote
Server Gate.
Use the toner recommended for this
machine.
Load the specified paper in the tray,
press [JobReset] to reset the job.
Install a new print cartridge.
For details, see "Replacing
Maintenance Kit", Maintenance and
Specifications .
109