11 Configure the settings relating to images and audio [Image/Audio]
11.7 Adjust the angular field of view using the extra
optical zoom function
Click the [Setup>>] button of "Extra optical zoom" on the [Image quality] tab of the "Image/Audio" page.
(®page 89)
It is possible to adjust the angular field of view using the extra optical zoom function.
•
: Click this button to adjust the zoom ratio to the "Wide" side.
•
: Click this button to set the zoom ratio to x1.0.
•
: Click this button to adjust the zoom ratio to the "Tele" side.
•
Note
•
When "2 mega pixel [16:9]" is selected for "Image capture mode", the maximum zoom ratio is x3.0.
•
When "1.3 mega pixel [16:9]" or "1.3 mega pixel [4:3]" is selected for "Image capture mode", the
maximum zoom ratio is x2.0.
•
When "3 mega pixel [4:3]" is selected for "Image capture mode", the maximum zoom ratio is x3.2.
IMPORTANT
•
The extra optical zoom function may not be activated on the appropriate position if the setting for the
function is performed after the settings for the mask areas (®page 96), privacy zone (®page 103),
VMD area (®page 120), VIQS area (®page 105), cropping area (®page 132), picture in picture
cropping area (®page 133). To prevent this, perform the setting for the extra optical zoom function
before other settings.
•
When using the lens distortion compensation function, if the extra optical zoom function is used, the
lens distortion compensation function is disabled.
102
Operating Instructions
: Click this button to adjust the horizontal and vertical positions of the image after zooming.