Adjust The Angular Field Of View Using The Extra Optical Zoom Function - Panasonic i-PRO WV-SPN531 Operating Instructions Manual

Click this button to close the "Back focus" setup menu.
11.6 Adjust the angular field of view using the extra
optical zoom function
Click the [Setup>>] button of "Extra optical zoom" on the [Image quality] tab of the "Image/Audio" page.
(®page 95)
It is possible to adjust the angular field of view using the extra optical zoom function.
•
: Click this button to adjust the zoom ratio to the "Wide" side.
•
: Click this button to set the zoom ratio to x1.0.
•
: Click this button to adjust the zoom ratio to the "Tele" side.
•
Note
•
When "2 mega pixel [16:9](30fps mode)" or "2 mega pixel [16:9](60fps mode)" is selected for "Image
capture mode", the maximum zoom ratio of the extra optical zoom becomes x3.0.
•
When "2 mega pixel [4:3](30fps mode)" or "3 mega pixel [4:3](30fps mode)" is selected for "Image
capture mode", the maximum zoom ratio of the extra optical zoom becomes x2.5.
IMPORTANT
•
The positions will move out of alignment if extra optical zoom settings are configured when the mask
area (®page 103), privacy zone (®page 108), VMD area (®page 129), VIQS area (®page 112),
or cropping area (®page 140) is configured. To prevent this, perform the setting for the extra optical
zoom function before other settings.
11 Configure the settings relating to images and audio [Image/Audio]
: Click these buttons to adjust the horizontal/vertical position of the image after zooming.
Operating Instructions 107