Using The Viewfinder; Using The Lcd Panel - Canon EOS C300 Mark II Instruction Manual

Preparing the Camera

Using the Viewfinder

The camera's viewfinder features an OLED screen that turns on
automatically when you look through the viewfinder. The screen also turns
off automatically shortly after you stop using the viewfinder.
40
Adjusting the Viewfinder
1 Gently pull out the viewfinder until it stops and adjust the angle as
necessary.
2 Turn on the camera and adjust the dioptric adjustment lever until the
viewfinder's image is sharp.
NOTES
• You can turn on the viewfinder permanently by setting [¢ Picture/Terminals Setup] > [Viewfinder Setup] >
[Eye Sensor] to [Off].
Attaching and Removing the Eye Cup
Attach the eye cup so that it covers the rubber rim of the viewfinder unit.
To remove the eye cup, pull it gently in a "peeling off" motion from the
bottom up.
• For left eye use, attach the eye cup so that the protruding part faces the
opposite side.
IMPORTANT
• Pointing the viewfinder lens at the sun or other strong light sources may
cause damage to internal components. When you are not using the
viewfinder, make sure to attach the viewfinder cap to the viewfinder.
This will also protect the viewfinder from scratches and dirt. Attach the
viewfinder cap by inserting it into the rubber rim of the viewfinder unit.

Using the LCD Panel

The whole monitor unit can be rotated 270º sideways allowing for
easy monitoring and operation from the side of the camera.
Additionally, the independently articulated LCD panel can be
rotated 180º sideways and 270º up and down. In combination, you
can position the LCD panel at a comfortable angle whatever the
shooting style you need.
1 Rotate the monitor unit sideways to the desired angle.
2 Open the LCD panel and adjust the screen to the desired
position.
Dioptric
adjustment lever
Eye cup
Viewfinder
unit