Installation Precautions - Majestic DV360 Homeowner's Installation And Operating Manual

DV360/580 Series Direct Vent Gas Fireplace
4. Remove air shutters from burner pan by removing
shutter retaining screw then air shutter. (Fig. 64)
5. For DV360 replace only rear air shutter.
Natural Gas: Rear air shutter, close half.
Front air shutter, fully open.
LP: Rear air shutter fully open.
Front air shutter fully open.
For DV580 replace only rear air shutters.
Natural Gas: Rear air shutter, fully open.
Front air shutter, fully open.
LP: Rear air shutter, fully open.
Front air shutter, fully open.
6. Re-install manifold to burner pan.
Burner Pan
Shutter
Retaining
Screw
Air
Shutter
Front View
CO103
Fig. 64 Remove air shutter from burner pan.
Gas Conversion
Air shutter
NOTE: It is not necessary to remove the pilot tube
2/15/99 djt
for conversion.
7. Remove pilot hood by lifting up. (Fig. 65)
8. Remove pilot orifice with allen wrench. (Fig. 66)
9. Install conversion pilot orifice.
10. Re-install pilot hood and be sure to align with index
tab. Installation is complete.
Pilot Hood
Pilot
Bracket
Fig. 65 Remove pilot hood.
Index Tab
Snap Ring
Fig. 66 Remove pilot orifice.
CO106a
38
DV360/580
Gas Conversion
Pilot2
1/28/00 djt
CO103
CO105a
Allen Wrench
CO105a
DV360/580
Gas Conversion
Pilot
1/28/00 djt
CO106a
Fuel Conversion Instructions
Honeywell Comfort Control Valve ONLY
WARNING: The conversion must only be
undertaken by a qualified, certified gas ap-
pliance installer.

Installation Precautions

Before proceeding, turn control knob on valve to OFF
and turn gas supply OFF. Turn OFF any electricity that
may be going to the appliance. CAUTION: Logs may
be hot!
Conversion Procedure
1. Open bottom grille to gain access to valve. Remove
glass door. (Refer to "Window Frame Assembly Re-
moval Section" Page 24, Fig. 47)
2. Remove logs if previously installed. CAUTION: Logs
may be hot!
3. Remove and replace plug on lower right hand side of
the valve; Red for LP and blue for NG. (Fig. 67)
Motor Top Cap
Local/
Pilotstat
Remote Switch
Knob
Fig. 67 Comfort control valve.
FP1037
4. Remove motor top cap. Depress and turn center
Honeywell
plunger until arrow points to correct screw. Red for
comfort valve
LP and Blue for NG. NOTE: Plunger will "snap" into
3/22/00 djt
NG position when arrow is close to blue screw. It will
not "snap" at LP (Red) position. (Fig. 68)
5. Remove manifold mounting screw. (Fig. 69)
6. Remove burner orifice from manifold assembly using
7/16" wrench. (Fig. 70)
7. Install conversion orifice in place of orifice just re-
moved. Refer to Table 2.
8. Remove both air shutters from burner pan by remov-
ing air shutter retaining screw then air shutter. (Fig.
71)
9. Install conversion air shutters on burner pan. Re-
place air shutter retaining screw. Adjust both air
shutters. Refer to Table 3 for proper air shutter
adjustment. Secure air shutter retaining screw.
Piezo Ignitor
OFF
•
LED
Plug
Antenna
FP1037
10006357