Remote Id Setup Mode - Denon AVR-X3100W Service Manual

4. Remote ID Setup Mode

4.1. Actions
This function allows only the desired AV receiver to be operated if multiple DENON AV receivers are used in the same
room.
4.2. Starting up
Hold down buttons "ZONE2 SOURCE", "DIMMER" and "STATUS" at the same time and press the power button to turn on
the power.
Select the "6. REMOTE ID" using the button "TUNER PRESET CH+ / -", and press the button "STATUS" to commit the
selection.
4.3. Operations
(1) When Remote ID Setup mode is started, the following is displayed.
FLD
R E M O T E
(2) Press the "QUICK SELECT 1 - 4" button that corresponds to the number you want to set.
Button
QUICK SELECT 1
QUICK SELECT 2
QUICK SELECT 3
QUICK SELECT 4
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
Only "QUICK SELECT 1 - 4" and the POWER button on the unit can be used in Remote ID Setup Mode.
b
The remote ID of the remote control supplied with this unit cannot be changed.
b
NOTE:
If the ID of the unit and remote control do not match, "AVAMP z " appears on the display of the unit when the remote
control is used (*: own remote control ID).
I D ?
Display
R E M O T E I D
R E M O T E I D
R E M O T E I D
R E M O T E I D
64
1
2
3
4