Remote Id Setup Mode - Denon AVR-S730H Service Manual

3-5. Remote ID Setup Mode

3-5.1. Actions
This function allows only the desired AV receiver to be operated if multiple DENON AV receivers are
used in the same room.
3-5.2. Starting up
AVR-X1400H
· While holding down buttons "ZONE2 SOURCE", "DIMMER" and "STATUS" simultaneously, press the
power button to turn on the power.
AVR-S730H
· While holding down buttons "TUNER PRESET CH+", "TUNE -" and "TUNE +" simultaneously, press
the power button to turn on the power.
Select the "6. REMOTE ID" using the "TUNER PRESET CH+/-" button, then press the "STATUS" button
then to confirm.
3-5.3. Operations
(a) When Remote ID Setup mode is activated, the following message is displayed.
REMOTE ID ?
(b) Press the desired "QUICK SELECT 1 - 4" button.
Button
QUICK SELECT 1
REMOTE ID 1
QUICK SELECT 2
REMOTE ID 2
QUICK SELECT 3
REMOTE ID 3
QUICK SELECT 4
REMOTE ID 4
(c) Press the power button to turn off the power.
(d) Press the power button to turn on the power.
b Only "QUICK SELECT 1 - 4" and the POWER button on the unit can be used in Remote ID Setup
Mode.
b The remote ID of the remote control supplied with this unit cannot be changed.
NOTE :
If the ID of the unit and remote control do not match, "AVAMP z " appears on the display of the unit
when the remote control is used
( z : own remote control ID).
Display
117