Denon AVR-X3100W Service Manual page 63

3.8. TUNER STEP mode (E2/E3 only)
3.3.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3.8.2. Starting up
Hold down buttons "ZONE2 SOURCE", "DIMMER" and "STATUS" at the same time and press the power button to turn on
the power.
Select the "5. TUNER FRQ SET" using the button "TUNER PRESET CH+ / -", and press the button "STATUS" to commit
the selection.
3.8.3. Displays
Start this unit in TUNER STEP mode, select using button "TUNER PRESET CH+/-" and enter using button "STATUS".
The following information is displayed in the following order.
(a) AM9kHz/FM50kHz selected
FLD
<
"TUNER PRESET CH+"
(b) AM10KHz/FM200kHz selected
FLD
< A M 1 0 / F M 2 0 0
(C) Press the power button to turn off the power.
(D) Press the power button to turn on the power.
A M 9 / F M 5 0
"TUNER PRESET CH-"
"STATUS"
>
>
63