Sp5-Xxx: Mode - Ricoh A-P4 Service Manual

5. Service Tables
This SP prescribes the number of times that the cleaning pattern of SP3905 004 is repeated for
jobs that are longer than the number of pages prescribed by SP3905 004.
[0~5/0/1]
Unless you change this setting, the cleaning pattern of SP3904 (1st Cleaning, then the 2nd
Cleaning after 35 sec.) is not repeated. If you change this setting to "1" for example, then the
pattern will be repeated once.
Job/HR stripper
This SP setting determines whether cleaning is canceled if another job starts while cleaning is in
progress.
006
0: New job priority (default)
1: Cleaning priority
Setting this SP to "1" ensures that every cleaning cycle executes completely before another job
5
is allowed to start.

SP5-xxx: Mode

5024 mm/inch Display
Selects whether mm or inches are used in the display. After selecting the number, you must
turn the power switch off and on.
Europe/Asia model: [0 = mm / 1 = inch]
American model: [0 = mm / 1 = inch]
5037 Status Lamp Mode
Determines whether the status lamp on the operation panel operates or not. If a customer finds
the flashing of this lamp disturbing, use this SP to switch it off.
[0~1/1/1]
0: Lamp operation off
1: Lamp operation on
TonerRefillDisp
Disables and enables the toner refill display. The display appears when the PCDU requires
5051
more toner. (Default: *Enable)
*Enable, Disable
206
Job/hot roller stripper cleaning priority setting
Status Lamp Mode
Toner Refill Display