Genie GS-1530 Operator's Manual page 19

Second Edition • Fifth Printing
22 Press and hold the function enable switch.
Slowly move the control handle in the direction
indicated by the yellow arrow.
Result: The platform should lower. The descent
alarm should sound while the platform is
lowering.
When lowering the platform, the platform should
stop when it is 2.1 m from the ground. Be sure the
area below the platform is clear of personnel and
obstructions before continuing. To continue
lowering, release the control handle, wait 5
seconds, then move the control handle again.
Test the Steering
Note: When performing the steer and drive function
tests, stand in the platform facing the steer end of
the machine.
23 Press the drive function select switch.
24 Press and hold the function enable switch on the
control handle.
25 Depress the thumb rocker switch on top of the
control handle in the direction identified by the
blue triangle on the control panel.
Result: The steer wheels should turn in the
direction that the blue triangle points on the
control panel.
26 Depress the thumb rocker switch in the direction
identified by the yellow triangle on the control
panel.
Result: The steer wheels should turn in the
direction that the yellow triangle points on the
control panel.
Part No. 82660 Genie GS-1530 and GS-1930 and GS-1532 and GS-1932
Test Drive and Braking
27 Press and hold the function enable switch.
28 Slowly move the control handle in the direction
indicated by the blue arrow on the control panel
until the machine begins to move, then return
the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
29 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
Test Limited Drive Speed
30 Press the lift function select button.
31 Press and hold the function enable switch.
Raise the platform approximately 1.2 m from
the ground.
Result: The pothole guards should deploy.
Operator's Manual
FUNCTION TESTS
17