Appliance Setup; Fixed Glass Assembly; Remove The Shipping Materials/Install Vanity Panel; Clean The Appliance - Heatilator CRAVE4836 Installation Manual

11 11

Appliance Setup

A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
1. Remove the decorative front from fi replace and set
aside on work surface.
2. Locate the glass latches that are on the upper edge of
the glass frame of the appliance. See Figure 11.1.
3. Use both index fi ngers to release the glass clips.
4. Allow glass to tilt forward. Grasp glass on the upper
return lip of glass frame and lift up and out. The glass
should lift easily out of the bottom retaining lip.
Replacing Fixed Glass Assembly
1. Locate retaining lip on lower front face of fi rebox.
2. Place glass assembly into retaining lip end. Tilt top of
glass assembly toward fi replace.
3. Assure proper left to right placement of glass and en-
gage all four spring latches.
GLASS CLIPS
BOTTOM RETAINING LIP
Figure 11.1 Fixed Glass Assembly
Heatilator • CRAVE4836/ST, CRAVE6048/ST, CRAVE7260/ST, CRAVE8472/ST Installation Manual • 2301-970 Rev. Q • 9/15
58
B. Remove the Shipping Materials/Install
Vanity Panel
Remove shipping materials from inside or underneath
the fi rebox. Verify all components are with the fi replace.
Unwrap the vanity panel and replace in the same location
as shown in Figure 11.2.
Figure 11.2 Vanity Panel Location
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.