Heatilator CRAVE4836 Installation Manual page 45

4. Turn the gas shutoff handle to the "OFF" position to
shut off the gas supply.
If additional access is needed, proceed as follows:
5. Remove glass assembly from appliance by unlatch-
ing the top spring latches from the glass frame and
lifting glass frame assembly out of the bottom brack-
et.
6. Remove interior media and refractory from the unit if
already installed.
7. Remove the media tray. It is attached to the interior
fi rebox bottom with ten screws. See Figure 9.3.
8. Remove the two screws that attach the pilot to the
burner.
9. Remove the four screws securing the burner to the
fi rebox sides and disengage burner from orifi ce. Re-
move burner. See Figure 9.3.
10. Remove the eight screws that secure the glass window.
Remove the glass window. Handle with care. See
Figure 9.4.
11. Remove light tray from appliance by lifting up and out
through the bottom glass opening.
PILOT SHIELD
BURNER ASSEMBLY
4836 & 6048
BURNER ASSEMBLY
7260 & 8472
Figure 9.3. Media Tray with Burner and Pilot Shield
Heatilator • CRAVE4836/ST, CRAVE6048/ST, CRAVE7260/ST, CRAVE8472/ST Installation Manual • 2301-970 Rev. Q • 9/15
MEDIA TRAY
Figure 9.4. Gas and Electrical Access - Remove Glass Window
GAS VALVE
GAS ACCESS
Figure 9.5. Gas Fitting Access with Vanity Panel Removed
45