Comfort Adjustments - Pride Mobility Legend XL Owner's Manual

V I I .
ARMREST ANGLE ADJUSTMENT
The armrest angle of your scooter can be adjusted up-
ward or downward. See figure 12.
n By turning the adjustment dial, the armrest angle
will either raise or lower.
NOTE: The ar mrests also pivot
upward to make getting on and off
of your scooter easier.
SEAT HEIGHT ADJUSTMENT
You can change the seat height to one of three positions
in 2.5 cm (1 in.) increments.
Changing the seat height:
1. Turn the scooter off and place the manual freewheel
lever in drive mode.
2. Lift the seat up and out of the seat post.
3. Loosen and remove the seat height adjustment bolt
and bolt-nut.
5. Slide the upper seat post up or down in the lower
seat post.
6. Align the adjustment holes on the upper seat post
and the lower seat post.
7. Reinstall the seat height adjustment bolt and bolt-
nut, then tighten.
8. Reinstall the shroud.
9. Reinstall and lock the seat into place.
30
C O M F O R T
www.pridemobility.com
A D J U S T M E N T S
Figure 12. Armrest Angle Adjustment
WASHER
BOLT-NUT
Figure 13. Seat Height Adjustment
Legend XL/Rev A/April 2003
ADJUSTMENT DIAL
UPPER SEAT POST
WASHER
SEAT HEIGHT
ADJUSTMENT BOLT
LOWER SEAT POST