Pride Mobility Legend XL Owner's Manual page 32

V I I I . D I S A S S E M B L Y
DISASSEMBLY
You can disassemble the scooter into seven pieces: the seat, the front section, the rear section, the rear shroud, the
basket, and the batteries. See figure 14. Place the scooter in an area where you have sufficient clearance to move
the parts around. You need about 1.5 meters (five feet) in all directions. You may need assistance to lift some of the
scooter components.
BATTERIES
Figure 14. The Legend XL Disassembled
No tools are required to disassemble or assemble your scooter. Always disassemble or assemble your scooter on
a level, dry surface with sufficient room for you to work and move around your scooter. Keep in mind that the
disassembled sections of the scooter take up more floor space than the assembled scooter.
WARNING! Lifting weight beyond your physical capability may result in personal injury.
Ask for assistance when necessary while disassembling or assembling your scooter.
1. Place the manual freewheel lever in the drive (down)
position.
2. Coil the charger power lead and store it for future use.
3. Lift the seat up and off the scooter.
4. Gently pull the shroud up and off of the rear section of
the scooter.
5. Disconnect the battery strap.
6. Unplug both T-handle battery harnesses. See figure 15.
7. Unplug the front-to-rear harness. See figure 15.
WARNING! Failure to unplug both T-handle
battery harnesses and the front-to-rear
harness prior to separating the front and
rear sections could result in permanent
damage to the scooter.
32
SEAT
REAR SHROUD
BASKET
www.pridemobility.com
A N D A S S E M B L Y
REAR SECTION
FRONT SECTION
T-HANDLE BATTERY HARNESS
FRONT-TO-REAR HARNESS
T-HANDLE BATTERY HARNESS
Figure 15. Harness Connections
Legend XL/Rev A/April 2003