Comfort Adjustments - Pride Mobility Sidekick Owner's Manual

V I I I .
TILLER ANGLE ADJUSTMENT
WARNING! Remove the key before adjusting the tiller. Never attempt to adjust the tiller
while the scooter is in motion.
You can adjust the tiller to any number of positions be-
tween the forward stop and the scooter deck. The tiller
adjustment lever locks the tiller in position.
1. Push down on the tiller adjustment lever. See figure 11.
2. Move the tiller to a comfortable position.
3. Release the tiller adjustment lever. The tiller remains in
the position you selected.
NOTE: In order to lower the tiller to the scooter deck,
you must first remove the seat and both batteries. See
IX. “Disassembly and Assembly.”
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to one of three different
heights.
1. Remove the seat and shroud from your Sidekick. See
IX. “Disassembly and Assembly.”
2. Use the attached ring to pull and remove the ball de-
tent pin from the seat post tower. See figure 12.
3. Raise or lower the seat pedestal to the desired seat
height.
4. While holding the seat pedestal at that height, match
up the holes in the seat pedestal and in the lower seat
post.
5. Fully insert the ball detent pin.
6. Reinstall the seat.
ARMREST WIDTH ADJUSTMENT
The Sidekick armrest width can be adjusted inward or
outward.
1. Loosen the armrest adjustment knobs at the back of
the seat frame. See figure 13.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs.
The armrests can also be lifted upward to allow getting
on and off of your Sidekick easier.
Sidekick
C O M F O R T A D J U S T M E N T S
FIGURE 11. TILLER ADJUSTMENT
SEAT PEDESTAL
LOWER SEAT POST
FIGURE 12. SEAT HEIGHT ADJUSTMENT
TILLER ADJUSTMENT
LEVER
BALL DETENT PIN
23