Disassembly And Assembly - Pride Mobility Legend XL Owner's Manual

V I I I . D I S A S S E M B L Y
Toggle Latch Release
1. Push in the toggle latch release
button while pulling back the
toggle latch. See figures 16 and
16A.
2. Position the toggle latch buckle
over the top of the toggle latch.
See figure 16B.
3. Lower the tiller to the scooter
floorboard.
Frame Separation
1. Push back on the seat post to
pivot the scooter’s rear section
rearwards until the rear section
is standing vertically on its
bumper. See figure 17.
2. Lift the front section up until the
lower pegs are no longer in the
slots. See figure 18.
3. Carefully move the front sec-
tion away from the rear section.
ASSEMBLY
1. Position the front and rear sections of your scooter as shown in figure 19.
2. Align the lower slots of the front section with the corresponding pegs on the front of the rear section. See figure 19.
WARNING! Position the front-to-rear harness cable so it won’t become pinched between
the frame halves when pivoting the rear section forward. See figure 19.
3. Holding the seat post, slowly pivot the rear section forward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figure 17.
4. Raise the tiller.
5. Secure the toggle latch. See figure 16A.
n Lower the toggle latch buckle.
n Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness and both T-handle battery
harnesses.
7. Reinstall the shroud.
8. Reinstall the seat, and lock it into place.
Legend XL/Rev A/April 2003
TOGGLE LATCH
TOGGLE LATCH
RELEASE BUTTON
Figure 16. Toggle
Latch (Latched)
Figure 17. Frame Positioning
www.pridemobility.com
A N D A S S E M B L Y
Figure 16A. Toggle
Latch (Unlatched)
Figure 18. Separating The
Frame Sections
CURVED LOCKING
PEG
BRACKET
FRONT-TO-REAR HARNESS CABLE
Figure 19. Frame Sections
TOGGLE LATCH
BUCKLE
Figure 16B. Buckle
Secured
33