Heatilator NDI30-C Owner's Manual page 36

LOG PIN LOG PIN
MATES WITH MATES WITH
LOG SLOT LOG SLOT
RIGHT GRATE TINE MATES RIGHT GRATE TINE MATES
FLAT SPOT FOR FLAT SPOT FOR
LOG #6 LOG #6
Figure 6. Log #3
Log #3 (SRV2224-702): Position Log #3 as shown in Figure 6. Refer to Figure 2 and Figure 7 for location of reference
points. Mate the log slot located on the bottom of Log #3 with the right log pin located on the burner top. Rotate the right
end of Log #3 forward until it contacts with the right grate tine.
4 4
LOG SLOT CONTACTS GRATE TINE LOG SLOT CONTACTS GRATE TINE
Figure 8. Log #4
Log #4 (SRV2224-703): Position Log #4 as shown in Figure 8. See Figure 2 and Figure 3 for additional details. Place
the top end of log #4 on the fl at spot of Log #1. Position Log #4 so the groove located on the right side of the forked end
contacts the left grate tine.
Log #5 (SRV2224-704): Position Log #5 as shown in Figure 9. See Figures 2, 3 and 6 for additional details. Position the
top end of Log #5 on the fl at spot of Log #1. Place the forked end of Log #5 on the fl at spot of Log #3.
6 6
MATE BASE TINE MATE BASE TINE
WITH LOG GROOVE WITH LOG GROOVE
Figure 10. Place Log #6
Log #6 (SRV2224-705): Place the short and long points of the forked end, on the fl at spots of existing logs as shown in
Figure 10. See Figures 2, 3 and 6 for additional details. Position the other end of the log so it rests on the base tine. The
base tine groove will mate with the base tine See Figure 11.
36 Heatilator • NDI30-C, NDI30-SP, NDI35-C, NDI35-SP, NDI30-SPFK, NDI35-SPFK • 2226-901 Rev. K • 11/12
FLAT SPOT FOR FLAT SPOT FOR
LOG #5 LOG #5
3 3
WITH LOG SLOT WITH LOG SLOT
LOG RESTS ON LOG RESTS ON
FLAT SPOT FLAT SPOT
LOG RESTS ON LOG RESTS ON
FLAT SPOTS FLAT SPOTS
GRATE TINE SLOT GRATE TINE SLOT
LOG SLOT LOG SLOT
Figure 7. Log #3
Figure 9. Place Log #5
Figure 11. Log #6
LOG RESTS ON LOG RESTS ON
FLAT SPOTS FLAT SPOTS
5 5
BASE TINE BASE TINE
GROOVE GROOVE
2224-935B