Heatilator NDI30-C Owner's Manual page 34

Figure 5. Place Log #3
Log #3 (SRV2226-706): Position Log #3 as shown in Figure 5. Refer to Figure 1 and Figure 6 for location of reference
points. Mate the slot located on the bottom of Log #3 with the log pin located on the left side of the burner. Move the left
end of Log #3 forward until it comes into contact with the grate tine.
PLACE TOP END OF PLACE TOP END OF
LOG ON FLAT SPOT LOG ON FLAT SPOT
Figure 7. Place Log #4
Log #4 (SRV2226-703): Position Log #4 as shown in Figure 7. See Figure 1 and Figure 2 for additional details. Place the
top end of log #4 on the fl at spot of Log #1. Position the forked end of Log #4 around the far left grate tine. Rotate the forked
end of the log to the left until the right fork touches the grate tine.
Log #5 (SRV2226-705): Position Log #5 as shown in Figure 8. Refer to Figures 1,2 and 3 for placement references. Position
the two forked ends of Log #5 on the fl at spots of Log #1 and Log #2. The thicker end of the logs rests on the grate bar.
Figure 9. Place Log #6
Log #6 (SRV2226-704): Position Log #6 as shown in Figure 9. See Figures 1, 2 and 3 for additional details. Rest the forked
end of Log #6 on the fl at spot of Log #2. Position the back end of the log on the fl at spot of Log #1. Figure 10 shows the
log set properly installed.
34 Heatilator • NDI30-C, NDI30-SP, NDI35-C, NDI35-SP, NDI30-SPFK, NDI35-SPFK • 2226-901 Rev. K • 11/12
LOG LOG
TOUCHES TOUCHES
GRATE TINE GRATE TINE
3 3
MATE LOG MATE LOG
PIN WITH PIN WITH
LOG SLOT LOG SLOT
4 4
LOG TOUCHES LOG TOUCHES
GRATE TINE GRATE TINE
LOG POSITIONED LOG POSITIONED
ON FLAT SPOT ON FLAT SPOT
FORKED END FORKED END
RESTS ON RESTS ON
FLAT SPOT FLAT SPOT
6 6
Figure 6. Log #3
5 5
LOG TOUCHES LOG TOUCHES
GRATE TINE GRATE TINE
Figure 8. Place Log #5
Figure 10. Log Set Installed
SLOT SLOT
END OF LOGS END OF LOGS
POSITIONED ON POSITIONED ON
FLAT SPOTS FLAT SPOTS
LOG RESTS ON LOG RESTS ON
GRATE BAR GRATE BAR
2226-935B