D-Link DSL-6540U User Manual page 67

High-speed vdsl2 router

Hide thumbs Also See for DSL-6540U:

Table of Contents

Note: If Enable Qos checkbox is not selected, all QoS is

disabled for all interfaces. The default DSCP mark is used to

mark all egress packets that do not match any classification

rules.

Click Save/Apply to active QoS.

4.3.7.2 QOS - Queue Config

Choose Advanced Setup > Quality of Service > Queue Config, and the

following page appears. In this page, you can configure QoS Queue. A maximum of

24 entries can be configured.

Qos Queue Configuration can allocate three queues. Each of the queues can be

configured for a precedence value (Lower integer values for precedence imply

higher priority for this queue relative to others). The queue entry configured is used

by the classifier to place ingress packets appropriately.

Note: Lower integer values for precedence imply higher

priority for this queue relative to others.

For example, add a QoS queue entry and allocate it to a specific network interface

(pppoe_0_0_35). Set integer values for queue precedence to 2.

Step 1

Click Add and the following page appears.

Table of Contents