Faceplate Installation; Standard Faceplate Offset Installation - Montigo 30FID Traditional Installation & Maintenance Manual

Hide thumbs Also See for 30FID Traditional:

Table of Contents

I-Series Indoor Gas Fireplace

Faceplate Installation

When the standard faceplate is used the install width of the

fireplace is 30 inches. If your install is smaller than 30 inches,

you can use the offset kit, which will allow you to decrease

the install size to 28 inches. This can only be done with the

standard faceplate kit. You must install the offset kit on the

standard faceplate before installing it on the appliance.

Figure 1 Sec.7 Standard Faceplate Offset Kit

Contents

1). Unpack the standard faceplate kit. Take the rear faceplate

and cut 0.325 inches away from the wire pass-through hole at

the bottom right hand corner.

Figure 2 Sec.7 Cutting away excess material

Page 26

Installation

2). Take the offset faceplate and peel the red protective plastic off

of the self-adhesive tape.

Figure 3 Sec.7 Peeling self-adhesive tape

3). Place the rear panel from the standard faceplate over top of

the offset trim. Press down on the adhesive to guarantee good

adhesion.

Figure 4 Sec.7

Figure 5 Sec.7 Offset Trim Installed on Rear Panel of Standard

Faceplate

4). Continue to standard faceplate installation section for

remainder of installation.

XG00524-

150909

Table of Contents