Section 8: Faceplate Installation - Montigo 30FID Traditional Installation & Maintenance Manual

I-Series Indoor Gas Fireplace
Standard Faceplate Installation
The Faceplate Surround has 2 main parts, the rear panel
and the front panel. The Rear Panel has an master override
switch installed on the upper right corner. The Rear Panel
has to be installed first.
Figure 15. The Rear Faceplate Panel
1). Remove the Lighting Instructions from the Control area and
leave on the floor in front of the unit.
Figure 15a.
2). Make sure that the attachment screw is installed in the small
tab at the lower front right part of the Rear Faceplate and the lower
left corner of the firebox shell.
Figure 15b.
Page 22
Installation
Figure 15c.
3) Lift the Rear Faceplate up and over the Magnets located the
top of the fireplace.
Figure 15d.
4) Temporarily, place the Electrical Cord through the hole in the
right side of the Rear Faceplate
Figure 15e.
XG00516-060614