Standard Or Oversized Faceplate Installation - Montigo 30FID Traditional Installation & Maintenance Manual

Standard or Oversized Faceplate Installation

The Faceplate Surround includes two main parts: the Rear
Panel and the Front Panel. The Rear Panel has a master
override switch installed on the upper right corner. The Rear
Panel must be installed prior to the Front Panel.
Brackets
supplied
Found behind
panel
Figure 6 Sec.7 Standard or Oversized Faceplate Kit Contents
1). Remove the Lighting Instructions from the Control area
and leave on the floor in front of the unit.
Figure 7 Sec.7
2). Install the Rear Faceplate Panel support brackets using
screws provided (4 locations). Ensure proper orientation of
the bracket.
Figure 8 Sec.7
XG00524- 150909
Installation
Screws
supplied
Figure 9 Sec.7
3) Align the Rear Faceplate with the front of the fireplace.
Figure 10 Sec.7 The Rear Faceplate Panel
4) . Temporarily place the Electrical Cord through the hole in the
right side of the Rear Faceplate.
Figure 11 Sec.7
I-Series Indoor Gas Fireplace
Page 27