Table of Contents
Advertisement
4. The emergency Shut-off valve needs to be placed in the "ON"
position, see section for operation. The pressure tap on the
left is to be used to measure supply line pressure. Refer to
the specifications at the beginning of this manual for the gas
pressure specs. Be sure to close and leak test all potential leak
areas prior to closing in the install. Using the remote, turn the
main burner on. Check the inlet pressure and the manifold
pressure on high and low. Refer to specification sheet for
acceptable values. Remove rubber tubes, close taps and check
for leaks. Close emergency shut-off valve reinstall the valve
mounting bracket. Make sure wires and pilot gas lines are not
pinched or kinked. Check pilot gas line for leaks.
Faceplate Installation
The Faceplate Surround has two main parts: the rear panel and the
front panel. The rear panel has a master override switch installed on
the upper right corner. The rear panel has to be installed prior to the
front panel.
FOUND BEHIND PANEL
16
Figure 5.6
Figure 5.7
1. Remove the Lighting Instructions from the Control area and
leave on the floor in front of the unit.
2. Install the Rear Faceplate Panel support brackets using screws
provided (4 locations). Ensure proper orientation of the bracket.
Figure 5.10
Installation
Figure 5.8
Figure 5.9
Figure 5.11
XG0528 - 170223
Advertisement
Table of Contents
