Faceplate Installation; Standard Faceplate Offset Installation - Montigo 30FID Installation & Maintenance Manual

Faceplate Installation

Standard Faceplate Offset Installation

When the standard faceplate is used the install width of the
fireplace is 30 inches. If your install is smaller than 30 inches,
you can use the offset kit, which will allow you to decrease
the install size to 28 inches. This can only be done with the
standard faceplate kit. You must install the offset kit on the
standard faceplate before installing it on the appliance.
Figure 1 Sec.7 Standard Faceplate Offset
Kit Contents
1). Unpack the standard faceplate kit. Take the rear faceplate
and cut 0.325 inches away from the wire pass-through hole at
the bottom right hand corner.
Figure 2 Sec.7 Cutting away excess material
XG0523-150909
Installation
2). Take the offset faceplate and peel the red protective plastic off
of the self-adhesive tape.
Figure 3 Sec.7 Peeling self-adhesive tape
3). Place the rear panel from the standard faceplate over top of
the offset trim. Press down on the adhesive to guarantee good
adhesion.
Figure 4 Sec.7
Figure 5 Sec.7 Offset Trim Installed on Rear Panel of Standard
Faceplate
4). Continue to standard faceplate installation section for
remainder of installation.
I-Series Indoor Gas Fireplace
Page 25