I-Series Indoor Gas Fireplace
Standard Faceplate Installation
The Faceplate Surround has 2 main parts, the rear panel
and the front panel. The Rear Panel has an master override
switch installed on the upper right corner. The Rear Panel
has to be installed first.
Figure 45 Sec.4
1). Remove the Lighting Instructions from the Control area and
leave on the floor in front of the unit.
Figure 46 Sec.4
2). Make sure that the attachment screw is installed in the small
tab at the lower front right part of the Rear Faceplate and the lower
left corner of the firebox shell.
Figure 47 Sec.4
Page 22
Installation
Figure 48 Sec.4
3) Lift the Rear Faceplate up and over the Magnets located the
top of the fireplace.
Figure 49 Sec.4
4) Temporarily, place the Electrical Cord through the hole in the
right side of the Rear Faceplate
Figure 50 Sec.4
XG0514-150204