Rheem R95P Installation Instructions Manual page 43

W RNING
UPFLOW FURNACE: THE SOLID METAL BASE
PLATE (SHIPPED WITH THE FURNACE) MUST BE IN-
STALLED IN THE FURNACE BOTTOM WHEN USING
SIDE AIR RETURN. FAILURE TO INSTALL A BASE
PLATE COULD CAUSE THE PRODUCTS OF COM-
BUSTION TO CIRCULATE INTO THE LIVING SPACE
AND CREATE POTENTIAL LY HAZARDOUS CONDI-
TIONS, INCLUDING CARBON MONOXIDE POISON-
ING OR DEATH. FOR BOTTOM RETURN, A SOLID
METAL BASE PAN MUST NOT BE INSTALLED.
FIGURE 8
1
REMOVE BLOWER
DOOR AS SHOWN
2
INSERT TAB ONTO
FLANGE AND PUSH
PANEL INTO PLACE
RETAINING TAB
DETAIL
INSTALLATION OF SOLID METAL BASE FOR SIDE
DOWNFLOW INSTALLATIONS
1. Position the unit to minimize long runs of duct or runs
of duct with many turns and elbows.
W RNING
A DOWNFLOW INSTALLATION IS CERTIFIED FOR
INSTALLATION ON A NON-COMBUSTIBLE FLOOR.
USE THE SPECIAL BASE SPECIFIED ON THE FUR-
NACE CLEARANCE LABEL. FAILURE TO INSTALL
THE SPECIAL BASE MAY RESULT IN FIRE, PROP-
ERTY DAMAGE, PERSONAL INJURY OR DEATH.
THIS BASE IS AVAILABLE AS AN ACCESSORY.
3
INSTALL SCREW IN TAB LOCATED
IN THE BLOWER COMPARTMENT
TAPE ALL EDGES OF BOTTOM
TO COVER GAPS
4
SEAL ALL
SEAMS TIGHT
WITH METAL
TAPE
RETURN APPLICATIONS
2. If summer air conditioning is desired, position the in-
door coil on the supply-air side of the unit. Ensure that
no air can bypass this coil.
3. If installing on a combustible floor and not using an
air conditioning plenum, install the special non-com-
bustible floor base. See Table 1 and Figure 11.
4. Connect the furnace to the supply air plenum.
5. Connect the return air ducting to the return air opening
at the top of the unit. Make the connection air tight to
prevent the migration of toxic fumes and odors includ-
ing carbon monoxide from migrating into the living
space from an adjacent fuel-burning appliance.
INTERNAL VIEW
OF BLOWER
COMPARTMENT
ST-A1194-49
NOTE: In downflow configuration, side return air cut
out is not permitted.
6. If a filter is installed near the furnace, be sure to
have adequate space for the unit filter.
NOTE: DO NOT take return air from bathrooms,
kitchens, furnace rooms, garages, utility or laundry
rooms, or cold areas.
DUCTING
43