Sharp LC-32WD1E/S/RU Service Manual page 24

LC-32WD1E/S/RU, LC-37WD1E/S/RU, LC-42WD1E/S/RU, and LC-32/37/42WT1E
8. When finished, a message similar to this will be displayed:
Note:
9. Close your PC application.
10. If you updated the GTV image (.hex file), it is possible the LEDs on the front of the TV will blink and illuminate for
approximately 30 seconds. This is the virgin TV Init process. Wait until the LEDs are off, and then the TV will start up
automatically.
Step 1: Visual notification for the start of the EEPROM TV initialization (3 sequences)
Step 2: Visual notification for the TV initialization / data writing (1 sequence):
Step 3: Visual notification for the end of the eeprom TV initialization (3 sequences)
11. Disconnect the Service PCB from the TV.
12. Disconnect the TV from AC power. Wait 10 seconds.
13. Connect the TV to AC power. The TV will turn on automatically. (Standby/On LED is GREEN.)
14. Complete the steps in the automatic setup.
15. Verify the TV was upgraded correctly. (See "Service Menu Settings" on page 9.)
If the upgrade fails, please power off the set and close the program. Then restart the
procedure.
5 - 5