Sharp LC-32WD1E/S/RU Service Manual page 22

LC-32WD1E/S/RU, LC-37WD1E/S/RU, LC-42WD1E/S/RU, and LC-32/37/42WT1E
[1.4] Analogue Upgrade Process
1. Disconnect the TV from AC power. Wait 10 seconds.
Do NOT go to standby first. Just unplug the power cord.
2. Connect the TV with the set up as described in "Analogue Upgrade Hardware Setup" on page 5-2.
3. Connect the TV to AC power.
4. Press to turn the TV on. (The Standby/On LED on the front of the TV is GREEN.)
5. Open ServUpdtArdV_vx_x.exe.
6. In ServUpdtArdV_vx_x.exe, be sure that the checkbox by Enter ISP is highlighted automatically.
Note: If Enter ISP is not automatically checked, try to select the Enter ISP button. If this does
not highlight the checkbox, close the application and re-check your setup as described in
"Analogue Upgrade Hardware Setup", power the TV on and off, and then start over at
step1.
5 - 3