Final Assembly - Model Tech Magic V2 Instruction Manual

q Use a couple of pieces of masking tape, taped between the aileron and the wing panel, to hold the aileron centered.
q Remove the masking tape and double-check that both the servo horn and the aileron are still centered. If necessary, thread
the clevis in or out to center the aileron, then move the aileron up and down several times to ensure proper movement. Repeat the
previous procedures to install the second aileron control linkage assembly.
IMPORTANT If you will be flying your airplane using a non-computer radio system without mixing capabilities, you will need to
plug a Y-Harness into the two aileron servo leads at this time. This will allow both aileron servos to be plugged into the aileron
channel in your receiver. If you will be flying your airplane using a computer radio with mixing capabilities, you may want to plug
each aileron servo lead into your receiver separately (into Ch. 1 and Ch. 6) to take advantage of your radio's mixing capabilities.
q (2) M2 x 6mm Flange-Head Wood Screws
q # 1 Phillips Head Screwdriver
q Modeling Knife
q Scissors
q Electric Drill
q 1/16" (1.6mm) & 5/64" (2mm) Drill Bits
steP 1: aPPLYiNG tHe DeCaLs
q Using a clean cloth, wipe the airframe down completely to remove any dust, debris and oil, then cut out each of the decals and
apply them using the box cover photos for reference. If any air bubbles form under the decals when you apply them, use a T-Pin to
puncture the air bubbles and release the trapped air, then press the decal down.
q Install the 90º bend in the pushrod wire into the hole that you enlarged
in the servo arm, using one snap-keeper.
+
The pushrod wire should be orientated on top of the servo arm.
q Center the aileron servo, then install the servo horn onto the servo,
making sure that the servo horn is centered and pointing out toward the
wing tip.
q Install the servo horn retaining screw to secure the servo horn to the
servo.
q With both the servo horn and the aileron centered, thread one clevis onto
the pushrod wire and snap the clevis into the outermost hole in the control
horn.

fiNaL asseMBLY

You'LL NeeD tHe foLLoWiNG Parts froM tHe Kit:
q (1) Decal Set
You'LL NeeD tHe foLLoWiNG tooLs aND suPPLies:
q Straight Edge Ruler
q Pencil
q Airplane Stand
q Masking Tape
Page