Error Message『Err1 - Nautilus M-7001 A Engineering Manual

Engineer Manual-Trouble Shooting
2.18. Error message『Err1』：Inverter no output after start.
Show Err1
Reset power
ON
Does the console show
after 10 seconds?
Press START to quick start.
Motor did not move then show
Err1？
Set incline to level 15 then set to
level 0.
Does the incline work abnormal
and stop then show
System operating normal but please check
t h e i n v e r t e r s h a l l b e t h e n e w v e r s i o n
a n d c o n s o l e f i r m w a r e v e r s i o n g r e a t
t h a n V 1 . 0 5 , i f n o t , r e p l a c e o r u p d a t e
i t .
OFF
Yes
『UArt』
Refer to 2.13. error
『UArt』
message
No
Replace inverter to newest version
Yes
(refer to 1.3.) and update the console
firmware version to the newest
version.(great than V1.05)
No
The incline motor jammed or input power too low, the input
Yes
power shall over 90V(110V system)/200V(220V system).
Err1？
After to e l i m i n a t e i n c l i n e m o t o r j a m m e d a n d i n p u t p o w e r
No
p r o b l e m , p l e a s e c h e c k t h e i n v e r t e r s h a l l b e t h e n e w
v e r s i o n ( r e f e r t o 1 . 3 . ) a n d c o n s o l e f i r m w a r e v e r s i o n
g r e a t t h a n V 1 . 0 5 , i f n o t , r e p l a c e o r u p d a t e i t .
Document NO. M-7001A-EM-English
PAGE Page 11 of 18
VERSION C