Lincoln Electric LINC FEED 34 Operator's Manual page 9

A. Non Synergic Welding Mode (CV Mode)
Description:
During Non Synergic (CV Mode) welding, the pre-setting of the welding parameters (Wire Feed Speed and Voltage) are
independent from one another.
Set-Up:
LF 34: This machine is always in Non-Synergic Welding Mode.
LF 35: While pressing the Prog button, rotate the left knob until
"NON SYNERGIC" appears on the display.
Before Welding (Pre-Set):
Pre-Set Wire Feed Speed
(Meters/Minute)
Adjust with left knob.
During Welding (Actual):
These actual values are displayed for 5 seconds after the weld has stopped. Press ENTER (LF 35 Only) to recall these
values.
Actual Welding Current
(A)
A-4
Pre-Set Welding Voltage
(V)
Adjust with right knob.
Actual Welding Voltage
(V)