Machine Drive Home Position - Pfaff PowerLine 2231 Setup Instructions

Commissioning
7

Machine drive home position

.02
7 Only on machines with drive P45 PD2-L
.02.01
● Switch on the machine.
● When the machine is commissioned, "Pulley" appears on the display.
● Call up the parameter input by pressing the scroll key.
● Press the TE key to switch the function keys to input function (LED in the TE key is
● Press the corresponding +/- keys to select parameter "798" and select the service level
● Select parameter "800" by pressing the corresponding +/- keys.
● Check whether the value is set at "1" (balance wheel turns towards operator) and alter if
● Press the scroll key until "Pulley" appears on the display.
● If the pedal is operated, the control unit carries out a teach-in operation.
● The machine runs at low speed until the teach-in operation is completed.
● This operation cannot be interrupted.
● After the teach-in operation, the "Pulley" disappears from the screen - display returns to
● Select parameter "700" by pressing the +/- keys.
● Sew one stitch by operating the pedal.
● Turn the balance wheel in the direction of rotation until the needle point, descending
● Conclude the adjustment of the sewing motor by pressing the scroll key.
7 Only on machines with drive P74 ED-L
.02.02
36
illuminated).
C, see chapter Selecting the User Level in the separate instruction manual for the control
panel.
necessary.
standard.
from above, is fl ush with the top edge of the needle plate.
On machines with EcoDrive P74 ED-L it is not necessary to check the basic
position of the machine drive unit.
These machines are equipped with an automatic sewing head recognition
function.