8
Machine drive home position / fi tting the toothed belt
.02.05
Switch the machine on.
Call up input mode.
Call up the service menu.
Enter the code number, see chapter 9.10 Entering / changing the code number.
Turn the motor shaft by hand until the display shows the value "11" under "POS" .
11
Turn the handwheel in the direction of rotation until the needle point (approaching from
above) is on the upper edge of the needle plate.
Fit the toothed belt 5 while making sure that both the motor shaft 4 (Fig. 8 - 08) and the
machine are not twisted.
Set-up and Initial Start-up
27