Configuring A Pxe Server - HP EliteBook 745 G2 Maintenance And Service Manual

Table 9-1 Power-On Troubleshooting (continued)
No link or activity on the network RJ-45 LEDs or
the LEDs do not illuminate blinking green after
powering on the computer. (The network LEDs
are located inside the RJ-45 connector on the
top, rear panel of the computer. Indicator lights
are visible when the connector is installed.)
A newly connected unknown USB peripheral
does not respond or USB peripherals connected
prior to the newly connected USB peripheral will
not complete their device actions.

Configuring a PXE Server

NOTE: All PXE software is supported by authorized service providers on a warranty or service contract
basis. Customers that call the HP Customer Service Center with PXE issues and questions should be referred
to their PXE provider for assistance.
Additionally, refer to the following:
– For Windows 2008 R2:
– For Windows 2012:
The services listed below must be running, and they may be running on different servers:
1. Domain Name Service (DNS)
2. Remote Installation Services (RIS)
NOTE: Active Directory DHCP is not required, but is recommended.
86 Chapter 9 Diagnostics and Troubleshooting
1.
2.
3.
4.
5.
6.
An unknown USB peripheral may be connected and disconnected to a running
platform as long as you do not reboot the system. If problems occur, disconnect
the unknown USB peripheral and reboot the platform.
http://support.microsoft.com/kb/891275
http://technet.microsoft.com/en-us/library/cc766320(WS.10).aspx
Verify that the network is not down.
Make sure the RJ-45 cable is good by installing the RJ-45 cable onto a known
working device—if a network signal is detected then the cable is good.
Verify the power supply is good by replacing the power cable to the unit with
a known working power supply cable and testing it.
If network LED's still do not light and you know the power supply is good,
then re-image the unit.
If network LED's still do not light, run the IP configuration procedure.
If network LED's still do not light, have the unit serviced.
ENWW