Table of Contents
Advertisement
5. Specify an operation that will perform if an alarm occurs.
• Alarm output1 / Alarm output2 : Select whether to set the alarm output if an alarm
is incoming, and specify the alarm output time.
• E-mail sending : Specify the use of email transfer in the alarm input setup.
• FTP sending : Specify the use of FTP transfer in the alarm input setup.
• Record : Specify the use of recording in the alarm input setup.
• Goto Preset : Moves to the specified preset location when setting the alarm input.
6. When done, click [Apply (
VA / MD
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <VA / MD>.
To set the Motion Detection
1. Select a motion detection mode.
2. Specify the use of motion detection.
3. Select a sensitivity level of the motion
detection.
The greater the level is, the lesser
movement will be detected.
4. Place the cursor at a point in the video
and drag it to whatever you need.
5. Specify whether or not the event area is
displayed.
- If you select <On>, a portion of the
selected area considered that an
event occurred will be boxed in white.
6. Specify the object size.
7. Specify the activation time and activation condition.
For more information about <Activation time> and <Action>, refer to "Alarm input". (page 88)
8. When done, click [Apply (
J
If you are controlling the Pan/Tilt/Zoom operation or fitting the focus of the camera, the motion
sensor may not work.
)].
)].
English _89
Advertisement
Table of Contents
