Table of Contents
Advertisement
installation & connection
Installing by surface attachment
M
SNP-3302H/3371H/3371TH cannot be installed on the surface of a wall or ceiling.
❖ Attaching Template & Installing installation base
1. Attach the provided template on the ceiling. Based on the template, drill a 88mm
hole in the ceiling and arrange the wires through the hole.
2. Install installation base as shown.
3. Before installing the exposed bracket, open the hinged door at the bottom of the
bracket as shown in the picture. Hold the knob on the hinged door to open it.
❖ Connect Terminal Wires
1. Connect the cables to the terminal block on the
hinged door. Refer to "Camera Wiring Interface
Board". (page 17)
2. Once the wiring is complete, close the hinged door.
J
Do not connect the camera to a power outlet until the
installation is complete. Supplying power while the
installation is in progress may cause fire or damage the
product.
32_ installation & connection
Template
Knob
Advertisement
Table of Contents
