LG MULTI F Engineering Manual page 49

F
MULTI
F
MULTI MAX
Preparing the Indoor Unit for
Installation
Removing the Front Panel
1. First pull the top of the front panel up (1A) and then out (1B).
2. Remove the two (2) screws at the bottom (2A), then lift off the front
panel (2B).
3. To completely detach the front panel, disconnect the panel connector
found at the top of the indoor unit (3).
Removing the Piping and Side Covers
1. Unscrew the center cover.
2. Remove the cover from the side of the indoor unit chosen for the piping connections,
and then knock out the piping access hole. If the refrigerant piping will be connected
through the back of the unit, the access hole does not need to be knocked out.
3. Remove any burrs that may have been made.
Preparing the Drain Hose
1. Remove the rubber stopper from the chosen side of the indoor unit.
2. Insert the drain hose into the handle of the drain pan.
3. Connect the drain hose to the field-installed drain piping.
ART COOL GALLERY INDOOR UNITS
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Installation and Best Layout Practices
Figure 50:Preparing for Installation.
1A
2A
3
Figure 51:Removing the Piping and Side Covers.
Access Hole
for Piping
Side cover
Figure 52:Preparing the Drain Hose.
Adhesive
Field-Installed
Drain Piping
Drain
Hose
1B
2B
Panel Connector
Choose a Side
for the Drain
Connections
Rubber Stopper
ART COOL GALLERY™ | 49