Energysaver ® Installation - Rinnai Energysavers RHFE-309FT Operation And Installation Manual

Energysaver
Connect Energysaver
1. Remove the plastic protection cap from the threaded gas inlet located at the rear of the
appliance.
2. Position the appliance gas inlet in line with the gas supply from the wall.
3. Attach gas supply pipe to the appliance gas inlet and tighten (finger tight). Appliance has a
R½ male fitting (15 mm).
Mark flue position
1. On the wall behind the appliance, mark the vertical centre line of the heater.
2. Mark the flue penetration position in accordance with the instructions in the Energysaver
Flue Installation Manual. Undo the gas connection and remove the heater. Cut flue
penetration(s).
Attach securing (wall) brackets
1. Mark out the securing bracket screw holes using the heater centre line as reference.
Model A
RHFE-309FT 250 mm
RHFE-559FT 350 mm
2. Attach the two securing brackets supplied to the wall using the two 8 g x
30 mm screws (or suitable equivalent).
Rinnai New Zealand
installation
®
to the gas pipe
®
B
624 mm
537 mm
B
Securing brackets
Heater centre Line
Floor Level
Energysaver
28 ®
RHFE-309FT and RHFE-559FT (01-10)
A
C L
Operation and Installation Manual:
®