Instructions - GE JV247 Series Owner's Manual And Installation Instructions

Installation Instructions
DAMAGE - SHIPMENT/INSTALLATION
• If the unit is damaged in shipment, return the unit to the
store in which it was bought for repair or replacement.
• If the unit is damaged by the customer, repair or
replacement is the responsibility of the customer.
• If the unit is damaged by the installer (if other than
the customer), repair or replacement must be made by
arrangement between customer and installer.
MOUNTING SPACE
24", 30" or 36" to
match cooktop
width
Bottom edge of
cabinet needs
to be 30" or
more from
the cooking
surface
66" or more
from the
floor to the
top of the
hood
NOTES:
,, Hood width may be greater than the width of the range
or cooktop, but it may not be smaller.
• Ensure the range or cooktop is installed per
manufacturer's installation instructions.
• If you are going to vent your range hood to the outside,
see the "Ducting Requirements" section for exhaust duct
preparation.
TOOLS YOU WILL NEED
Flat-blade and Phillips Pencil
screwdrivers
Saw (saber or Electric drill
keyhole)
Duct tape
Metal snips
(in some
applications)
1/4" Pliers
pivoting
hex socket
Flashlight Caulking
Tape measure
Level
Wire stripper
!/4" Nutdriver
PARTS INCLUDED
PART QUANTITY
Grease Filter only (JV338) 1
Charcoal Filter only 1
(JN327 and RN328)
Grease Filter and Charcoal Filter 2
(JV24X,JV347, JV348, JV367
and AV447)
i_ Mounting Screws 4
(8 - 18" x 3//4" Phillips pan
head)
<__ Exhaust Adaptor 1
(for 3¼" x 10" rect. venting)
Exhaust Adaptor Screw 1
(8 - 18" x 3/8" Phillips pan
head or hex head)
8